What if we do not dismantle the straight optical axis according to the specifications?

In order to improve the interchangeability of linear optical axis, sliders are usually installed in bearings for use, so special attention should be paid to the operation. Especially in the case of the need for its tilt, the slider will move, so to prevent the occurrence of sliding phenomenon. Every part of the normal linear optical axis is made of high-quality materials, even with good performance but also need to be properly protected to avoid damage.
Before docking, it is necessary to ensure the flatness and straightness of the base mounting datum plane and the side datum plane. The smaller the height difference after docking, the better the docking. Secondly, tighten the installation screws when fixing the guide rail on the base in order to ensure that the seam gap is small and there is no dislocation between the upper and lower and left and right sides, and then completely lock the installation screws. It should be noted that do not damage the docking end of the guide rail, otherwise the slider will run irregularly, affecting the accuracy of use. Optic axis
To talk about the piston rod processing process, must be in accordance with the relevant provisions of processing, from coarse to fine, first outside is the inside, from the mechanical processing to heat treatment processing methods and other basic principles, so as to produce a good product.